Model slicing
When the size and direction of the model are set, choose the imported slicing parameters, and
click "Slice with CuraEngine". See picture (6-29, 6-30).
You can find the model information such as estimated print time, the amount of filament needed,
etc. Click "Print" to start USB printing. Refer to picture (6-31).
The printer will heat to the target temp and then start printing. Under high temperature, the
filament will flow out of the nozzle, which is normal. You can use tweezers to clean up the
residual material of the nozzle.
SHENZHEN GETECH TECHNOLOGY CO., LTD
(Picture 6-28)
(Picture 6-29)
(Picture 6-30)
45