Table of Contents
Advertisement
Setup mode allows the selection of the Temperature unit,
Auto‑off, Beep, the type of pH buffer set, the Resolution and
Information. To enter Setup mode press and hold
until "STD" and
tag. Release the button.
• "TEMP" is displayed on the
secondary LCD with the current
temperature unit (E.g. "TEMP °C"),
for °C/°F selection, use the SET button.
After the temperature unit has been
selected, press
selection.
• Use the SET button, to cycle
through the auto‑off choices:
8 minutes ("8", default value), 60
minutes ("60") or disabled ("---").
Press
"BEEP" selection.
• To switch ON or OFF the beep
tone, press the SET button;
press
the calibration buffer selection
"pH 7.01 BUFF".
• To change the type of calibration
buffer set, the meter will show
the current buffer set: "pH 7.01
BUFF" (for standard buffer set:
3.00/7.01/10.01) or "pH 6.86
BUFF" (for NIST buffer set: 3.00/6.86/9.18). Change
the set with the SET button. Press
enter pH resolution selection "RESOL".
• To change the pH measurement
resolution between "0.1" and
"0.01" use the SET button; then
press
electrode calibration information
"INFO" selection.
14
tag is replaced by "SETUP" and
to confirm and to enter the "A-OFF"
to confirm and to enter the
to confirm and to enter
to confirm and to enter
button
to confirm and to
Advertisement
Table of Contents
