Disconnect Seat Wire Harness - Yale GLP20LX Service Manual

Hood, Seat, and Side Covers Replacement
14. Remove two capscrews and washers from cover
plate and remove electrical cover. Disconnect
seat harness from chassis harness. See Figure 7.
CAUTION
When removing the seat from the hood, do not
use an impact wrench to remove the capscrews.
Damage can be caused to the threads on the cap-
screws and in the holes.
15. Open hood and pull chassis harness through hole
in hood. See Figure 8.
A. NON-SUSPENSION SEAT
1. CAPSCREWS
2. WASHER
3. COVER PLATE
8
Figure 7. Disconnect Seat Wire Harness
Remove the four capscrews and nuts holding the
seat to the hood. Lift the seat off the hood. See
Figure 8. Close hood.
16. Remove the nuts from ball studs on gas springs.
Remove gas springs from the hood. See Figure 9.
17. Remove the hinge capscrews and nuts, located in
the rear of the hood. See Figure 9.
18. Lift the hood from the truck.
B. FULL SUSPENSION SEAT
4. ELECTRICAL CONNECTOR (SEAT HARNESS)
5. ELECTRICAL COVER
0100 YRM 1766