Step By Step Guide - Firecell Hub/Rcc To Rcc Surveying - EMS FireCell FC-868-SE2 User Manual

Step By Step Guide - FireCell Hub/RCC to RCC Surveying

Note: a Hub/RCC to RCC Survey Form is supplied on page 20.
Step 1.
Position the Signal Surveyor in the proposed Radio Hub
location.
Step 2.
Turn on the Signal Surveyor.
Step 3.
Record the background level displayed, for future reference.
Refer to the Using the Signal Surveyor section for more
information.
Step 4.
Turn on the Device Survey Tool.
Step 5.
Position the Device Survey Tool against the wall in the
positions of the proposed RCC position.
Step 6.
Record the signal level.
Step 7.
Repeat Steps 5-6 for all RCC positions as required.
Note: the Surveyor Unit can be moved to an identi ed
!
RCC location to further expand the coverage. Up to
four hops from an RCC to the Hub can be achieved.
©2018 EMS Ltd. All rights reserved. Page 19 of 24
Surveyor
in Hub
position
CH 1 CH 2 CH 1 CH 2
POWER/
CHARGE
RSSI/dB
TX
START
RX
LOCAL - REMOTE REMOTE - LOCAL
START
SURVEYOR
DEVICE
LOCAL - REMOTE PASS / FAIL
Setting up comms
Surveyor Vxx.xx
REMOTE - LOCAL
SIGNAL QUALITY %
BATTERY
Steps
5 to 6
MK144 (Iss 3) 30/10/2018 AJM
CH 1 CH 2
RSSI/dB
LOCAL - REMOTE