Standards Compliance; Fcc Compliance Statement; Usage Of This Device - Wireless Solution W-DMX TRX Implementation Manual

1 Standards Compliance

1.1 FCC Compliance Statement

This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
To assure continued compliance, any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate this equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in
a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try and correct the interference by one or more of the following measures:
• Reorient or locate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
When the device is installed in the carrier equipment, included label "Contains FCC ID: NY2-WDMXTRXDB" must be
fastened on product label on the bottom of the unit.
The module will be installed by Wireless Solution during production of host equipment or by Wireless
Solution trained service technicians.
RF Exposure Warning for North America
RF Exposure: This device complies with part 2.1091 of the FCC rules for an uncontrolled environment. This
equipment shall be installed and operated with a minimum distance of 20cm (7.9 in.) between the antenna and the
user.

1.2 Usage of this device

This device is certified to be used together with the following units and antennas from
Wireless Solution
Host products:
BlackBox F-1, A40001G4MK2-X
WhiteBox F-1, A40002G4-X
WhiteBox F-2, A40004G4-X
BlackBox F-2, A40005G4MK2-X
ProBox F-2500, A40007G4-X
WhiteBox R-512, A40101G4-X
BlackBox R-512, A40102G4MK2-X
Antennas:
A40511G4, omnidirectional antenna with 4.0dBi gain
Revision 4
Author: Anders Zellén
6(23)
Wireless Solution Sweden Sales AB
Stureparksvägen 7 – 451 55 Uddevalla – Sweden
+46 522 511 511 Tel. +46 522 440 885 Fax.
Wirelessdmx.com sales@wirelessdmx.com
14/11/2014