Status Indicator Led - Wireless Solution W-DMX TRX Implementation Manual

7.1.5 Status Indicator LED

The Status LED indicates the current status of the wireless connection and the presence of
DMX data. The status is valid after start-up process has finished after ~1.7s (worst case) from
power on
The LED is active high, and should be connected between J1:5 and ground, for example J1:7
via a series resistor.
The LED output can deliver a maximum of 15mA. For the average LED a series resistor of
330ohms will work well.
The indications below are valid during steady state, that is in normal running mode after the
boot loader has finished.
/ "Off" denotes a dark LED and
7.1.5.1 LED Indication - Receiver:
Continuously Off = not assigned to a transmitter
On 900ms / Off 100ms = assigned to a transmitter, but no DMX present
Continuously On = assigned to a transmitter and DMX present
On 100ms / Off 100ms = link to transmitter lost or linking to transmitter
7.1.5.2 LED Indication - Transmitter:
On 900ms / Off 100ms = no DMX present
Continuously On = DMX present
On 100ms / Off 100ms = linking receivers
On 500ms / Off 500ms = unlinking all receivers
Revision 4
Author: Anders Zellén
14(23)
/ "On" denotes a lit LED.
Wireless Solution Sweden Sales AB
Stureparksvägen 7 – 451 55 Uddevalla – Sweden
+46 522 511 511 Tel. +46 522 440 885 Fax.
Wirelessdmx.com sales@wirelessdmx.com
14/11/2014