Philips SBC HD 1502 Instructions For Use Manual page 22

XP SBC HD 1500/17 for USA 14-01-2004 13:34 Pagina 22
22 ENGLISH
4 Power on your audio source: switch on your audio source, i.e. stereo TV,
stereo VCR, (S)VCD player, tape recorder, etc.
5 Output adjustment of your audio source: in case the line output of your
audio source has an adjustable output level, adjust the line output level of
the audio source to the highest acceptable undistorted level.
Note: In case of certain TVs, the line output level can only be
6 Power on the base station: switch on the digital wireless base station.
The power indication LED of the base station will change from red to
green.
7 Sensitivity switch: if your audio source's output signal is relatively weak, the
sensitivity switch at the back of the digital wireless base station should be
changed from 0dB to +6dB.This will provide the necessary additional
amplification to the audio input signal prior to processing.
If this results in a distorted signal, then set the switch back to 0dB.
8 Source select: select the analogue input on the base station by pressing
the 'Source' button.
9 Input signal detection: once a stereo audio signal is detected the input
signal indicator 'STEREO' will be illuminated.
Note: In case of multilingual NICAM transmissions, you should select
adjusted through the TV's on screen menu.
the appropriate language in your TV's menu. In that case the
audio signal will no longer be stereo but only mono and the
effect of for example Dolby Pro Logic II or Dolby Headphone
will very be limited.