Audio Connections - Philips SBC HD 1502 Instructions For Use Manual

XP SBC HD 1500/17 for USA 14-01-2004 13:34 Pagina 21

Audio connections

OPTION 1: ANALOGUE STEREO SOURCE:
Connecting the digital wireless base station to an
analogue stereo source (stereo TV, stereo VCR,
(S)VCD player, tape recorder, etc.)
Base station
1 Connect one side of the RCA stereo audio cable (included) to the line
output of the audio source and the other side to the analogue input of
the base station.
Make sure the red RCA plug (right channel) is connected to the red
connector (right channel) of the audio source.The white RCA plug (left
channel) must be connected to the white connector (left channel) of the
audio source.
2 Next take the RCA cable that most likely came supplied with your
analogue audio source. Connect one side of this second RCA stereo
audio cable (not included) to the line input of your amplifier or home
cinema receiver and the other side to the analogue output of the base
station.
When connecting your audio equipment in this way, you will be able to benefit
from the Automatic Audio Signal Routing (AASR) feature. As long as the base
station is powered – even in stand-by mode – the audio signal from the audio
source will be made available not only to the digital wireless base station but it
will be routed through to the rest of your home entertainment set-up. Without
the need for swapping cables you can decide whether you wish to enjoy the
audio through your wireless headphones or through for example the speakers of
your home entertainment system.
3 Check if the red RCA plug (right channel) is connected to the right
channel (red) of the audio source.
The white RCA plug (left channel) must be connected to the white
connector (left channel) of the audio source.
ENGLISH 21