Advertisement
Installation
1
1
Remove the cable cover by
pressing down on the latch and
sliding outward.
2
2
Install USB cable and route
cable through the bottom of the
opening as shown.
3
3
Reinstall the cable cover.
4 4
(Optional) The monitor can
be attached to any standard
75mmx75mm VESA mounting
bracket using the 4 - M4x8mm
mounting screws included with
the monitor.
5
5
Plug the other end of the cable
labeled "DATA cable" to a USB
port on the computer.
NOTE: Some computers may
require additional power by
plugging the "Aux Power Cable"
connector into an additional USB
port.
6
6
Install the DisplayLink and touch
drivers on your computer.
Note: This monitor can not
function as primary display
during boot-up. An additional
display must be used to install
the DisplayLink driver on the
computer.
DATA Cable
AUX Power
Cable
Advertisement
