Canon iX6500 Series Service Manual page 12

11 times Carriage lift
mechanism
error
12 times APP position
error
APP position
error during
initial purging
14 times APP sensor
error
16 times Pump roller
sensor error
17 times Paper eject
encoder error
the print head and the logic board
in set. (Be sure to replace them at
the same time.)
(3) Head contact pin condition of the
carriage unit:
If the pin is bent or deformed,
replace the carriage unit.
(4) Cable connection:
- CR FFC (J502, J501, J500)
Re-connect the cable.
If any damage or breakage of the
cable is found, replace the carriage
unit.
[5110] (1) Foreign material that obstructs the
carriage movement:
Remove foreign material.
[6A80] (1) Cap absorber and wiper blade of the
purge drive system unit:
If the cap absorber contacts the
wiper blade, lower the cap
absorber so that it will not contact
the wiper blade.
(2) Foreign material around the purge
drive system unit:
[6A81]
Remove foreign material.
(3) Ink absorber right beneath the purge
drive system unit:
Confirm that the absorber stays in
place and does not contact the unit.
(4) Foreign material around the ASF unit:
Remove foreign material.
(5) Cable connection:
- PE sensor cable
- Motor multi harness ass'y
Re-connect the cables.
[6A90]
If any damage or breakage of the
cable is found, replace the cable.
(6) APP slit film condition:
Clean the APP slit film using lint-
free paper.
(7) APP code wheel gear condition:
If the gear wears, replace the gear.
[5C20] (1) Cable connection
Re-connect the cable.
[6010] (1) Smearing on the LF slit film:
Clean the LF slit film using lint-
free paper.
8 / 52
- Switch system unit
- Carriage unit
- Purge drive system
unit
- Logic board ass'y
- Purge drive system
unit
- Timing slit disk feed
film
- Timing sensor unit