Generator Parameters; Tanφ2-Cosφ2 Target; Generator Input Enable/Disable; Modbus Rtu Settings - KAEL Muhendislik Elektronik VARkombi-12-PC-TFT-OG Manual

Connection type selective, 12 step, reactive power control relay, industrial facilities, markets, oil stations, schools, workshops, hotels

Hide thumbs

Table Of Contents

Table of Contents

1 7 10 8

Setting –

Advanced Setting Menu

VARkombi-12-PC-TFT-OG does not have this function.

1 7 10 9

Setting –

Advanced Setting Menu

1 7 10 9

Setting –

Advanced Setting Menu

This is the section which is used to give writing allowance to the

device parameters when connection is made externally via MODBUS

RTU.

The required condition is selected for function by using

up or down keys. "Select" key is pressed to take them

into the memory. "Save changes?" message will appear

on the screen. Pressing "OK" key, the value is taken into

the memory.

1 7 10 9

Setting –

Advanced Setting Menu

This is the section which is used to give reading allowance to the device

parameters and data when connection is made externally via MODBUS

RTU.

The required condition is selected for function by using

up or down keys. "Select" key is pressed to take them

into the memory. "Save changes?" message will appear

on the screen. Pressing "OK" key, the value is taken into

the memory.

1 7 10 9

Setting –

Advanced Setting Menu

The password should be entered to write data. This is the section in

which the password is entered. The value is setup to the required

value by using the up and down key starting from the digit where the

blue line is. Then left key is pressed and the blue underline moves

next to the left digit. All values are entered in the same way by using

up and downkeys. "Select" key is pressed to take them into the

memory. "Save changes?" message will appear on the screen.

Pressing "Okay" key, the value is taken into the memory.

P.S.: The security increases when giving different passwords for

writing and reading data.

1 7 10 9

Setting –

Advanced Setting Menu

The password should be entered to read data. This is the section in

which the password is entered. The value is setup to the required

value by using the up and down key starting from the digit where the

blue line is. Then left key is pressed and the blue underline moves

next to the left digit. All values are entered in the same way by using

up and downkeys. "Select" key is pressed to take them into the

memory. "Save changes?" message will appear on the screen.

Pressing "Okay" key, the value is taken into the memory.

P.S.: The security increases when giving different passwords for

writing and reading data.

–