Eaton COOPER POWER Series Assembly And Installation Instructions Manual
For s&c smd-20 fuse
Hide thumbs
Also See for COOPER POWER Series:
- Installation, operation and maintenance manual (189 pages) ,
- Installation, operation and maintenance instructions (128 pages) ,
- Manual (52 pages)
Related Manuals for Eaton COOPER POWER Series
Summary of Contents for Eaton COOPER POWER Series
- Page 1 COOPER POWER Fusing Equipment Effective November 2016 SERIES Supersedes MN132018EN September 1998 (S240-84-1) X-Limiter™ Hinge-Mount for S&C SMD®-20 Fuse Mounting Assembly and Installation Instructions...
-
Page 2: Disclaimer Of Warranties And Limitation Of Liability
CONTENTS OF THIS DOCUMENT SHALL NOT BECOME PART OF OR MODIFY ANY CONTRACT BETWEEN THE PARTIES. In no event will Eaton be responsible to the purchaser or user in contract, in tort (including negligence), strict liability or otherwise for any special, indirect, incidental or consequential damage or loss whatsoever, including but not limited to... -
Page 3: Table Of Contents
Contents DISCLAIMER OF WARRANTIES AND LIMITATION OF LIABILITY . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ii SAFETY FOR LIFE . -
Page 4: Safety For Life
FOR LIFE FOR LIFE Eaton meets or exceeds all applicable industry standards relating to product safety in its Cooper Power™ series products. We actively promote safe practices in the use and maintenance of our products through our service literature, instructional training programs, and the continuous efforts of all Eaton employees involved in product design, manufacture, marketing, and service. -
Page 5: Product Information
Current Transfer Surface CAUTION Clamp Screw Locating Pin Eaton’s Cooper Power series X-Limiter Hinge-Mount Upper Seal fuse is designed to be installed in accordance with Actuating Pin Through normal safe operating procedures . These instructions are Locating Slot Upper Seal When Fuse... -
Page 6: Fuse Replacement
X-Limiter™ Hinge-Mount for S&C SMD®-20 Fuse Installation of X-Limiter hinge-mount fuse with end CAUTION fittings into SMD-20 cutout: Refer to manufacturer’s operating procedure for installation of fuse into cutout. In accordance with Figure 2, verify that gaps are eliminated between the top of the upper-end fitting and the upper seal on the fuse . - Page 7 X-Limiter™ Hinge-Mount for S&C SMD®-20 Fuse his page is intentionally left blank. Mounting AsseMbly And instAllAtion instructions MN132018EN November 2016...
- Page 8 United States Eaton.com/cooperpowerseries © 2016 Eaton All Rights Reserved Eaton is a registered trademark. Printed in USA For Eaton‘s Cooper Power series product Publication No. MN132018EN Rev. 0 information call 1-877-277-4636 or visit: All trademarks are property www.eaton.com/cooperpowerseries. November 2016...