Tennant 9000136 Instruction Bulletin

INSTRUCTION BULLETIN
NOTE: DO NOT DISCARD the Parts List from the Instruction Bulletin. Place the
Parts List in the appropriate place in the machine manual for future
reference. Retaining the Parts List will make it easier to reorder
individual parts and will save the cost of ordering an entire kit.
Installation instructions for kit number 9000136

SYNOPSIS:

This kit contains the parts needed to install the 650mm disk head assembly on T7/SSR machines.
Please follow step-by-step instructions.
SPECIAL TOOLS / CONSIDERATIONS: NONE
(Estimated time to complete: 1 hour)

PROTECT THE ENVIRONMENT

Please dispose of packaging materials, old machine components,
and hazardous fluids in an environmentally safe manner according
to local waste disposal regulations.
Always remember to recycle.

PREPARATION:

1. Empty the solution and recovery tanks. Refer
to the Operators Manual for instructions.
2. Park the machine on a clean level surface and
if necessary raise the scrub head. Turn off the
machine.
3. Remove the brushes from the machine.
4. Turn on the machine and lower the scrub
head and squeegees.
5. Turn off the machine and remove the key.
FOR SAFETY: Before leaving or servicing
machine, stop on level surface, turn off the
machine, and remove the key.
IB 340753 (01- 2007)
6. Disconnect the battery cables from the
batteries.
WARNING: Always disconnect battery
cables from machine before working on
electrical components.
7. Jack or lift the front end of the machine
between 6" and 12" from the floor, slide the
jack stands underneath the machine, and
lower the machine onto the jack stands. Refer
to the Operators Manual for instructions.
FOR SAFETY: When servicing machine, block
machine tires before jacking up machine. Use
a hoist or jack capable of supporting the
weight of the machine. Jack machine at
designated locations only. Support machine
with jack stands.
Home
No. 340753
Machine: T7/SSR
Published: 01- 2007
Rev. 00
1