Tennant 9002378 Installation Instructions

KIT NO. 9002378
Models: T7 / Speed Scrub Rider
This kit is intended for machines manufacturered
before serial #10266229.
The purpose of this kit is to help prevent dam-
age to the newly installed circuit board.
KIT CONTENTS
P/N DESCRIPTION
41141 Washer, Lock, Int--Ext, 0.31 ZN
09010 Screw, Hex, M8x1.25X25 SS
1030479 Wire Assy, 12.0X.312X.312 Ring Term.
INSTALLATION INSTRUCTIONS:
Installation Time: 1 Hour
TOOLS REQUIRED: 13mm & 1/2" socket
wrenches, continuity tester or VOM meter
1. Park the machine on a clean, level surface.
2. Turn off the machine and remove the key.
3. Unplug the positive battery cable at the red
connector (Figure 1).
WARNING: Electrical Shock Hazard.
Disconnect Battery Cables Before Servicing
Machine.
4. Disconnect the operator seat connector
from the main wire harness and lift the seat
from the machine (Figure 1).
5. Remove the FaST detergent pack
(if equipped) and remove the FaST deter-
gent holder from the front of the battery
compartment shroud (Figure 2).
9002379 Rev. 00 (02--06)
GROUND KIT, STATIC
QTY.
4
1
1
Fig. 1
6. Remove the two bolts that secure the
battery compartment shroud and lift the
shroud from the machine (Figure 3).
7. Remove the bolt and flat washer that
connect the control panel mount to the
actuator mount (Figure 4).
Tennant Company Customer Service: (800) 553--8033 or (763) 513--2850
Page 1 of 3
Fig. 2
Fig. 3
Fig. 4