D-Link DCH-Z122 Manual page 7

Pir motion sensor
Table of Contents

Advertisement

NO
Vali
Name
Def.
A B C
.
d
  
0
  
0
  
1
  
0
  
0
  
0
  
0
  
0
  
8 PIR Re-
3
1 ~
Detect
127
Interval
Time
Description
the range is from 0x00 ~ 0xFF.
Bit0: Reserve.
Bit1: Enable sending motion OFF
report. (0:Disable, 1:Enable)
Note: Depends on the Bit4,
0: Report Notification CC,
Type: 0x07, Event: 0xFE
1: Sensor Binary Report,
Type: 0x0C, Value: 0x00
Bit2: Enable PIR super sensitivity
mode. (0:Disable, 1:Enable)
Bit3: Disable send out BASIC OFF
after door closed. (1:Disable,
0:Enable)
Bit4: Notification Type,
0: Using Notification Report.
1: Using Sensor Binary Report.
Bit5: Disable Multi CC in auto report.
(1:Disable, 0:Enable)
Bit6: Disable to report battery state
when the device triggered. (1:Disable,
0:Enable)
Bit7: Reserve.
In the normal mode, after the PIR
motion detected, setting the re-detect
time. 8 seconds per tick, default tick is
3 (24 seconds).
Setting the suitable value to prevent
NO
Vali
Name
Def.
.
d
Turn Off
0 ~
9
Light
4
127
Time
Auto
Report
0 ~
10
12
Battery
127
Time
30
Auto Report
0 ~
20
Tick
0xFF
Interval
7
Description
A B C
received the trigger signal too
frequently. Also can save the battery
energy.
Notice: If this value bigger than the
configuration setting NO. 9. There is a
period after the light turned off and
the PIR not start detecting.
After turn on the lighting, setting the
delay time to turn off the lighting
when the PIR motion is not detected.
  
8 seconds per tick, default tick is 4 (32
seconds).
0 means never send turn off light
command.
The interval time for auto report the
battery level.
  
0 means turn off auto report battery.
The default value is 12. The tick time
can setting by the configuration No.20.
  
The interval time for auto report each
tick. Setting this configuration will
effect configuration No.10, No.11,
No.12 and No.13.
The unit is 1 minute.
Caution1: Setting to 0 means turn
off all auto report function.
Caution2: The value is unsigned
byte, the range is from 0x00 ~ 0xFF.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents