Walrus Pump Co., Ltd. Address: No.83-14, Dapiantou, Sanzhi Dist., New Taipei City 252, Taiwan Declare that the machinery described: Name : Water Pump Model : TPH Series Conform to the following directive: 2006/42/EC—Machinery directive 2014/35/EU—Low voltage directive 2014/30/EU—EMC (Electromagnetic compatibility) directive...
1.1 Applications from weather and frost. Please do not allow The TPH Series are modernly designed with quiet and any foreign objects fall into the motor fan high efficient operation pumps, suitable for dependable cover.
Priming plug 2.3 The pump should be installed so that the suction pipe is as short and the suction lift as small as possible. 2.4 When draw liquid from the same level of the pump suction inlet, please allow a downward slope from the liquid source to the pump suction inlet to avoid air sucked in.
Please carefully follow all instructions in the Low Voltage High Voltage manual as Walrus may refuse to accept the 6.4 12 Wire, 3 Phase contaminated pump for servicing. 5.5. If the supply cord is damaged, it must be...
7. Fault finding (Make sure to disconnect the power before attempting to diagnose any fault.) Fault Cause 1. Check if electrical power source, fuse or circuit breaker failed. 1. Pump does not start 2. Check if pump is locked up by sand, rust or any foreign objects.
Page 7
TPH 8/12 Outlet Rp 1½" PS / " ( Or Rp 2 ") Inlet Rp 1½" ( Or Rp 2 ") PS / " 4-Ø8.5 TPH 8T TPH 12T Model Model TPH 8T 2 K TPH 12T 1K TPH 12T 2K TPH 8T 2.5K TPH 12T 3K TPH 8T 3 K...
Limited Warranty Products manufactured by Walrus Pumps Co (Walrus) are warranted to the first user only to be free of defects in material and workmanship for a period of 12 months from date of installation, but no more than 24 months from date of shipment. Walrus' liability under this warranty shall be limited to repairing or replacing at our election, without charge, FOB Walrus' distribution center or authorized service agent.