2014/35/EU—Low voltage directive 2014/30/EU—EMC (Electromagnetic compatibility) directive 2009/125/EC— Ecodesign Directive Electric motors: Commission Regulation No 640/2009. Applies only to three-phase Walrus motors marked IE2. See motor nameplate. Standard used: EN 60034-30:2009. Refer to the following standards: EN ISO 12100:2010 EN ISO 13857:2008...
1. Application 1.1. The TPHK series is multi-stage centrif- ugal pump designed for industrial use, especially for machine tools. 1.2 The pump can not be used to transfer explosive liquids;...
4. Installation 10. The max head : The pump has hot surface on the motor. It must be installed so that Model 50Hz 60Hz persons cannot accidentally come TPHK 2T (n) -1 into contact the hot surface. TPHK 2T (n) -2 4.1.
6.3. The pump is filled with liquid. fer toxic or contaminated liquids. 6.4. The suction filter is not blocked by any Please carefully follow all instructions foreign bjects. in the manual as Walrus may refuse to accept the contaminated pump for servicing.
11. Fault Finding Make sure electricity supply has been switched off before attempting to diagnose any fault Fault Cause 11.1 Motor does not start a. No electricity supply b. Fuses are blown. c. Motor overheating relay tripped. d. Defective magnetic contactors. e.
12 months from date of installation, but no more than 24 months from date of shipment. Walrus' liability under this warranty shall be limited to repairing or replacing at our election, without charge, FOB Walrus' distribution center or authorized service agent.