Related Manuals for Helios FML64PL
Summary of Contents for Helios FML64PL
-
Page 1: Assembly Instructions
Assembly Instructions FML64PL FML64PL • Please read these instructions carefully before using. • Please read these instructions carefully before using. • This model will hold most 32-65 Flat Panel TVs. • This model will hold most 32-65 Flat Panel TVs. -
Page 2: Supplied Parts And Hardware
Never use defective parts, improper installation may cause damage or serious injuiry. Do not • This product will hold most 32-65 Flat Panel TVs. use this product for any purpose that is not explicitly specified by Helios. Helios is not liable for • Load capacity: 34kg (75 lbs). -
Page 3: Safety Warning
4pcs 8pcs bolt 4pcs • Do not use the Helios FML 64PL for any purpose other than that specified by Helios. Helios is not liable for damage or injury Hardware for TV assembly： caused by incorrect assembly, mounting or use. - Page 4 Installation and Mounting Directions Step 3: Mount the Wall Plate (A) to the wall. Drywall with Stud mounting: The Wall Plate (A) must be mounted directly to two wood studs with a minimum distance of 16” between the studs. Once you have located the correct studs and height for the installation, hold the Wall Plate (A) in position against the wall, verify with a level and mark the bolt location for each stud (Figure 1).
- Page 5 Step 5 ： Attach TV connecting unit to TV. Installation and Mounting Directions width should be at Option 1 VESA:75*75mm,100*100mm. Unit 1 Lay TV face down,choose the suitable hareware and Step 4: Attaching Mount to your display or the Wall Plate TV .Pls keep the TV level(figure 6).
- Page 6 Once you have the Slide Arm Mount (E) in use this product for any purpose that is not explicitly specified by Helios. Helios is not liable for the desired location secure into place by tightening the the two screws at the damage or injury caused by incorrect mounting, incorrect assembly, or incorrect use.
- Page 7 Unit 2 Lay TV face down,fix (D) onto (B),and then slide (C) onto (B),using the correct screws to fix them on the back of TV(figure 7). Step 6: Hanging display Hang assembled display on Slide Arm Mount (E). Two people are required for this portion of the installation. Do NOT attempt to do this part of the installation alone.
- Page 8 figure 11 Note:This step requires 2 or more professional to finish. Step 6: Adjust the TV angle and manage the wire Check and tighten all screws you can use handle (2) to adjust tilt angle . Please tighten (2) when Step 8: Tilt the screen is in a desired angle.