Advertisement
Step 6: Hanging display
Hang assembled display on Slide Arm Mount (E).
Two people are required for this portion of the installation. Do NOT attempt to
do this part of the installation alone.
figure 6
Note:This step requires 2 or more professional to finish.
Step 6: Adjust the TV angle and manage the wire
Note
Check and tighten all screws you can use handle (2) to adjust tilt angle . Ple
the screen is in a desired angle. Please manage the wire to avoid damage b
figure 8
turning and fix the wire clip with the wire tie according to the length of the wir
Step 7: Horizontal leveling of your display.
In order to level your display loosen the two screws located on the back
Note: Please manage the TV wire and do not twist the wire on the turning
1.Pls use the corresponding screw&washer for the holes of the TV back,Asseble with incorrec
and bottom of the Connecting Plate (D), this will allow the display to tilt
When fixing the wire clip, please be sure the TV can extend the farmost d
several degrees left or right. Once you have your display in the desired
position re-tighten the screws.
2.Professional Knowledge required to assemble the flat panel TV and the wall mount and need
at least 2 people to finish this mounting procedure.Do not intent to assemble this wall mount
independently to avoid incorrect assembly or any possible injury this may caused.
figure 10
figure 11
6
figure 7
Sole intallation
prohibited
figure 9
+5°
figure
-15°
Advertisement
