Installation
2.5.10
Wiring transmitter to control system
Connect the Net Safety Millennium Transmitter to the control system as shown in
Figure
Table 2-5:
Transmitter Connections
Marking
RST
Function
Remote reset
2.5.11
External ground
In order to ensure proper operation of the sensor, an external earth ground is
recommended. Net Safety recommends that the external ground be connected to the
grounding point on the enclosure. Refer to
Figure 2-13:
A.
2.6
Current output
To set the current output, simply move the jumper located on the terminal board near the
power terminals, to the isolated or non-isolated current position. Refer to
18
2-11.
Table 2-5
outlines the terminal marking and their purpose.
+24V
10.5-32 Vdc
Connection
External grounding point
External grounding
COM
Common / supply
Current loop output
ground
Figure 2-13
for grounding connection location.
4-20
+VISO
+24 Vdc isolated
(mA)
4-20 power
Figure
2-14.
Millennium Air Particle Monitor