Electrolux LST15 Instruction Manual page 8

Hydraulic Installation
Water Inlet hose
Attach the end of the hose that comes loose on faucet,
so that it is fully threaded.
Open the faucet and check for leaks.
It is required to use a faucet at water inlet with
3/4" thread.
The use of a low quality faucet will damage the hose
of your washing machine causing water leakages.
IMPORTANT
The hose is provided with a filter that
prevents the entry of dirt that may come
through the water supply lines.
Do not connect the hot water hose (hot
water label) to the cold water faucet of
your residence.
Water pressure
To ensure a proper filling pressure, there must be a
minimum height of 2.4 m between the base of the
waterbox and the washing machine inlet.
Note: The inlet water pressure should be between
0.02 and 0.8 MPa. If the pressure is higher, use a
pressure reducer.
Do not use hot water with temperature
higher than 50 °C.
8
Drain hose
Place the hose in the drain outlet or at the edge of the
laundry sink with a maximum height of 140 cm and
a minimum of 90 cm for the proper operation of your
product.
Place the hose into the tube with a maximum of 20 cm
in the drain outlet.
When placing the hose on the edge of the laundry sink,
make sure the hose end is not submerged in the water tank,
b e c a u s e t h e
water can return
inside the
w a s h i n g
machine.
Never attach
t h e d r a i n
h o s e t o
another hose
to increase
the length. It
may damage
the internal
s y s t e m o f
water outlet.
In some locations, it is possible that the water supplied is dirty.
In this case, install a filter in
the faucet to avoid stains on clothes.
This filter can be bought at the Electrolux Service Center.