Electrolux LST15 Instruction Manual page 7

Electrical Installation
WARNING
Before connecting your
product, check if the voltage
in the socket where the
product will be plugged
is the same as the voltage
indicated on label located on
the plug (of the power cord).
There is a protection system to prevent the damage
to the electrical system of your washing machine.
If your washing machine is connected at a voltage
different from that of the label, an automatic
recognition system of voltage will not allow the
washing machine to work. But it will not cause any
damage to the electrical system of the washing
machine. Disconnect the plug from electrical socket
and make sure the voltage is correct.
For your safety, ask for a qualified electrician to check the
condition of the electric grid in the product installation
location. For more information, contact the
Electrolux Service Center.
When inserting the plug into the socket, a small click is
normal and when removing it, a small movement of the
. drum and/or agitator can also occur.
WARNING
Connect your product to
an exclusive socket. Do not
use extension cords or T
type adaptors. Do not use
adaptors.
Ground Wire
Your product is equipped with a 3-pin plug. Plug it into
a properly grounded electrical socket. The ground wire
pin of the plug cannot be cut.
Circuit Breaker
It is mandatory to install an exclusive circuit breaker for
the washing machine.
If in doubt, regarding the electrical system of your
residence, consult the energy provider .
Voltage 127 V
Neuter
Tripolar
socket
Tripolar
plug
Ground wire
For a 127 V product, use a 20 A circuit breaker in the
line and a 20 A tripolar socket.
Voltage 220 V - Bipolar
Tripolar socket
Tripolar
plug
Ground wire
For a 220 V product (between two lines), use a 15 A
bipolar circuit breaker and a 20 A tripolar socket.
Voltage 220 V - Monopolar
Neuter
Tripolar
socket
Tripolar
plug
Ground wire
Some regions have 220 V between line and neutral. In
this case, use a 15 A circuit breaker in the line.
Blackout
Occasionally, there may be blackouts due to
thunderstorms or other causes. Unplug the power
cord from the electrical socket when there is a blackout.
Once power is restored, plug the power cord into the
electrical socket. If the blackout is extended for a long
period, clean the washer before reuse.
20 A
circuit
breaker
Line cable
15 A
bipolar
circuit
breaker
Line cable
15 A circuit
breaker
Line cable
7