Electrolux LST15 Instruction Manual page 18

Probable Causes / Correction
If product heats
up on the external
surface of product
If display panel
E01
shows error
If display panel
E02
shows error
If display panel
E03
shows error
If display panel
Failure in the air exhaust temperature sensor.
E04
shows error
If display panel
Failure in the input sensor.
E05
shows error
If display panel
Failure in the communication protocol between
E06
shows error
the electronic boards.
If display panel
The is no inlet air filter of dryer or filter mis-
E07
shows error
placed.
If display panel
E08
shows error
If display panel
E09
shows error
If display panel
E10
shows error
If display panel
E11
shows error
18
Product is running a drying program.
Wrong voltage.
The clothes are unbalanced.
The drying system is not working.
Fail in automatic lid lock.
The exhaust filter of dryer is clogged.
Overflowing water.
Heating element circuit open. Thermostat
failure.
It is normal. During the drying of the clothes,
product heats the air and thus its outer surface
becomes hot.
Check the correct voltage for your product.
Redistribute the clothes in the drum, close the
lid and press the START/PAUSE key.
Call the Local Service Center.
Call the Local Service Center.
Call the Local Service Center.
Call the Local Service Center.
Replace the air inlet filter of drying.
Call the Local Service Center.
Clean the filters with the ON/OFF key activated
(panel ON).
Call the Local Service Center.
Call the Local Service Center.