Hamworthy LILIPUT HE Installation, Commisioning And Maintenance Instructions page 17

B
B
HAMWORTHY HEATING LTD
Hook the RH and LH
side covers over the
spacers and tie rods
and secure using the
nuts and bolts.
Screw the RH and LH
rear covers to the end
of the side covers
using the 4x10 self
tapping screws.
B
A
B
Hook the front cover
over the locating
heads in the side pan-
els
B
Remove the cable entry blanking plate (A) from the control con-
sole and screw the control panel to the top cover using the 4x10
self tapping screws (B).
Carefully push the thermostats and thermometer capillaries
through the entry hole and locate bulbs in the pocket at the top
front of the boiler.
Connect the power supply to the panel by running cable
through a cable entry in the rear panel and through the hole into
the control panel terminal block using the strain relief clamp
provided and run cable to the burner.
12
LILLIPUT HE
View showing the
front (B) and rear (A)
connection points for
the side covers.
A
Note that the insula-
tion jacket has to be
pushed under the
front location point to
allow the cover to
B
hook over.
Push the top cover
B
onto the location
studs in the top edge
A
of the side cover.
Making sure the cable
entry hole (A) is at the
front of the boiler. Se-
cure the top cover to
the rear cover using
the 4x10 self tapping
screws (B).
500001047/F