Figure 7: Two Position Shutter Assembly
Maintenance & Service
The power supply unit contains no user serviceable parts. Return the power supply unit to
Newport for any service issues that may arise.
OPERATING INSTRUCTIONS FOR LASER HEAD WITH POWER SUPPLY
The cylindrical construction of the laser head allows for easy mounting in ring clamps, V-blocks,
or similar mounting hardware without affecting the laser's alignment. Use caution when clamping
onto the laser as too much pressure can damage the aluminum housing or cause misalignment.
The front bezel has four each 4-40 Unified National Coarse Thread (UNC) holes to secure an
optional accessory mounting ring. The ring (part number R-30646), which is available for purchase
from Research Electro-Optics, has 1" diameter, 32 threads-per-inch (TPI) female threads.
Installation
Laser system includes a laser head and a power supply.
• Configure the AC power supply as directed in the "Operating Instructions for Power
Supplies" section above.
• Insert the remote interlock connector into the back of the power supply.
• Plug the two prong high voltage cable from the laser into the front of the power supply.
Confirm that the plug is well seated.
• Insert the key into the front panel of the power supply.
BASIC TROUBLESHOOTING
Once the laser and power supply have been properly connected, the laser system will operate
without maintenance.
troubleshooting take all precautions as if the laser system is fully operational.
Below are some guidelines if your system is not operating. When
REF-177
10