REF-174 UNPACKING • Inspect the packing container for any damage that may have occurred during shipment. • Contact the shipper immediately if the laser or control box has been damaged during shipping. • Packing materials are specifically designed to protect against shipping damage. •...
Page 4
Recommended Eyewear Maximum Permissible Nominal Ocular Part Number Description Optical Density (OD) Exposure (MPE) W/cm2 Hazard Distance (NOHD) (m) 32734 LASER SYSTEM, 633nm, STBLZD, >1.5mW 0.28 0.0026 5.63 32172 LASER SYSTEM, 3.39µm, 2.0mW, POL 30990 LASER SYSTEM, 633nm, 5.0mW, RANDOM 0.74...
Page 5
REF-174 Each helium-neon laser system that is certified to be in compliance with the CDRH regulations, is equipped with a key-switch, remote interlock connector, emission indicator, time delay relay (built into the laser system), a beam attenuator (or shutter, located in the front bezel of the laser housing), and all appropriate warning labels.
REF-174 LASER SYSTEM The line tunable laser system comes packaged in an aluminum housing which contains all of the components of the system. The housing is equipped with a sliding beam attenuator (or shutter) mounted to the front panel. The shutter assembly has four each 4-40 Unified National Course Thread (UNC) holes to secure the optional accessory mounting ring.
REF-174 • Turn both the color selector knob and the transverse adjustment knob clockwise until they stop. Do not force knobs past stopping point. • Look at laser label for proper settings of color selector knob and transverse adjustment knob. •...
Page 8
REF-174 BASIC TROUBLESHOOTING Once power is applied to the laser it will emit a beam of light within 10-15 seconds. If this does not happen, the following are some quick checks that can be performed to troubleshoot the laser system. •...
REO website and published specification sheets, under normal use and service when correctly installed and maintained. REO will either repair or replace (at REO’s sole option) any defective or nonconforming Product or part thereof which is returned at Buyer’s expense to REO’s facility, provided, that Buyer notifies REO in writing promptly...
Page 10
(equivalent to 3 inch thick high density foam on all sides) and insure that the power supply and tube are secured within the box so they do not move during shipment. REO will not assume responsibility for any shipping damages unless the laser is sent in REO-supplied packaging.
REF-174 EU DECLARATION OF CONFORMITY CE Compliance refers to following model numbers: Part Number Description 32734 LASER SYSTEM, 633NM, STBLZD, >1.5MW 32172 LASER SYSTEM, 3.39UM, 2.0MW, POL 30990 LASER SYSTEM, 633NM, 5.0MW, RANDOM 30025 LASER SYSTEM, 633NM,1.5MW,POL, 9.5" 31007 LASER SYSTEM, 633NM, 0.8MW, POL 31008 LASER SYSTEM, 633NM, 0.5MW, RAN...
Need help?
Do you have a question about the 32734 and is the answer not in the manual?
Questions and answers