LASER SYSTEM
The line tunable laser system comes packaged in an aluminum housing which contains all of the
components of the system. The housing is equipped with a sliding beam attenuator (or shutter)
mounted to the front panel. The shutter assembly has four each 4-40 Unified National Course
Thread (UNC) holes to secure the optional accessory mounting ring. The ring (part number 30646),
which is available for purchase from Research Electro-Optics, incorporates 1" diameter, 32
threads-per-inch (TPI) female threads. The back panel of the laser system contains the key-switch,
remote interlock connector, fuse access, the color adjustment knobs, and a three-foot long power
cord for connecting to either 115 VAC (System Model Number 30602) or 230 VAC (System Model
Number 30603) input power.
Figure 2: Back Panel of Laser System
Assembly of Laser System
• Plug the laser AC power cord into the power connector on the back panel.
• With the key switch in the "OFF" (vertical) position, plug the AC power cord into an
appropriate power source.
• Insert the remote plug into the interlock receptacle.
OPERATION
• Turn the key switch to the "ON" (horizontal) position and the emission indicator LED will
illuminate.
• Slide the two position shutter assembly to the "ON" position.
• Use a neutrally colored diffusively reflective card (e.g. card stock) or panel placed
approximately 10" (25cm) in front of output aperture in order to see lasing beam while
adjustments are made.
REF-174
6