Savaria Toyota Sienna Owner's Manual page 32

3. Flip the bench forward (see "Flipping the bench up", above).
4. With one person standing at the driver's side and one at the
passenger side, slide the bench towards the rear of the vehicle until
the three black seat anchors are aligned with the larger end of the
corresponding keyholes.
5. With the holes aligned, carefully lift the bench up out of the van
and set it down out of harm's way. Do not store the bench in the
upright position as it may fall and cause injury.
Installation:
1. Lift the bench into the van while lining up the large end of the
keyholes in the plate with the black seat anchors in the floor.
2. Slide the bench forward until the black seat anchors are bottomed
out against the small end of the keyholes in the plate. When the
plates are in the correct position, the hole at the front will be lined
up with the threaded bushing underneath.
32
Locked
Thumb Screw
Remove
thumb screw
Slide plates
rearward to
align anchor
Rearward
bolt heads
with large end
of keyholes
Unlocked
(Top view of passenger side plate)
Large end
of keyhole
Anchor
bolt head