Savaria Toyota Sienna Owner's Manual page 25

3. Slide the base towards the rear of the vehicle until the three black
seat anchors are aligned with the larger end of the corresponding
keyholes.
4. Carefully lift the base and remove it from the vehicle through the
side door.
Black anchor bolts
Thumb screw
Installation:
1. Lift the seat into the vehicle. The larger end of the three keyholes
on the bottom of the base should line up with the bolt pattern on
the vehicle floor.
2. While ensuring the rear claw is lined up with the hook in the floor,
slide the base in the forward direction until the black anchor bolts
bottom out against the end of the keyhole. The front thumb screw
hole will not line up unless the three black anchor bolts are fully
positioned, and the rear claw and hook are fully engaged.
3. Install the front thumb screw by lining up the screw post with the
front threaded hole and turning it in a clockwise direction while
firmly pressing downward. Thread it all the way down, and ensure it
is hand-tight.
Claw on base
Remove thumbscrew
Locked
Slide base rearward
to unlock
Locked
Unlocked
Unlocked
25