Savaria Toyota Sienna Owner's Manual page 15

6. The rear of the wheelchair may now be secured to the rear
retractors. Attach the J-hooks to the rear of the wheelchair frame
in the locations outlined in your wheelchair manual. Refer to the
Q'Straint Instruction Guide for ideal fastening geometry. Allow
the retractor to spool in and remove excess slack in the tie-down
once the J-hook has been attached. The tie down can be tightened
further by rocking the wheelchair back and forth or by turning the
knob on the side of the retractor. Two rear retractors are required
per wheelchair.
Refer to your wheelchair manual for instructions on selecting the most appropriate
wheelchair securing locations.
Be careful to keep straps away from sharp edges or corners.
All Q'Straint automatic retractors have a red tab located at the rear of
the unit. This tab is used to release the locking mechanism within the
retractor allowing the user to either extend the tie down or release the
wheelchair from its restrained position.
15