Occupant Restraint System - Savaria Toyota Sienna Owner's Manual

3.3 Occupant Restraint System

1. The supplied Q'Straint occupant restraint system is made up of
three parts: a lap belt, a belt buckle and a shoulder belt. The
system should only be used on the vehicle with which it was
supplied, and only as a complete unit. The system is not deemed
safe for use if any one or more parts are not available, or are not
used correctly.
2. The D-rings on the lap and buckle belts attach to the anchor pin
located on the top of each rear retractor. Attach these D-rings as
illustrated in the image below. The lap belt section attaches to the
driver's side rear retractor, and the buckle section attaches to the
passenger's side rear retractor.
lap belt
1
3. Pass the free ends of the belt buckle and the lap belt through the
right and left sides of the wheelchair, where they will be positioned
as low as possible across the pelvis of the wheelchair occupant.
shoulder belt
belt buckle
lap belt
belt buckle
2
17