Stoelting C111 Owner's Manual page 8

EN GLIS H
C 1 1 1
21)
figure 21
6 Remove the spigot assembly and disassemble it, following
the sequence specified. (see figure 22)
figure 22
7 Remove the auger. (see figure 23)
figure 23
8 Remove the auger coupling and seal. (see figure 24)
figure 24
9 Remove the drip tray. (see figure 25)
6. 4. 2 WASHING
IMPORTANT
If the power supply cable is damaged, it must be replaced
by the manufacturer or an authorized service provider to
avoid all risk.
ATTENTION
Before any cleaning operation, always disconnect the
dispenser from the power source.
1 Fill a bucket with approximately one gallon of 90-110 °F
water) and 1 oz of mild detergent (Stera-Sheen green label),
following the manufacturer's instructions. A solution that is too
concentrated may damage the parts to be washed, whereas
one that is too diluted may not clean properly. Do not use any
abrasive detergents.
IMPORTANT
In order to avoid damaging the machine, only use deter-
gents that are compatible with plastic components.
2 In order to avoid damaging the machine, only use
detergents that are compatible with plastic components.
ATTENTION
When cleaning the machine, do not use excessive
amounts of water around the electrical components. This
could cause electric shocks or damage to the machine.
3 Wash the freezing cylinder, the hopper, and the mix inlet
tube using the brush supplied with the unit.
4 Rinse all washed parts under running water.
6. 4. 3 SANITIZING
Sanitizing must be done immediately before starting up the
dispenser. Do not allow the dispenser to remain idle for a long
time after sanitation.
8
figure 25