Nordson EFD 2K Instruction

2K Pneumatic Dispense Gun: 600mL Instructions
1
O-Ring
4
Handle Nut
Steps
1. Remove top handle assembly.
2. Remove ejectors & carriage (note ejector relation to rods).
3. If cartridge ratio is not 1:1, remove rod assembly by loosening
piston bolt. If ratio is 1:1 move on to step 6.
4. Rotate piston 180 degrees.
5. Rotate rod assembly 180 degrees and assemble.
6. Rotate carriage 180 degrees and re-attach.
7. Reassemble ejectors to rods noting their correct placement.
8. Unscrew main handle leaving the union tube in place.
9. Attach suitcase handle using handle nuts and screws.
10. Lube o-rings with grease and insert union tube into suitcase handle.
11. Attach main handle to suitcase handle using handle nuts and screws.
2
Union Tube
5
Handle Screws
3
Main Handle
6
Screws
Handle
4 Main Nut
Assembly
(13 mm)
Tools required
Phillips-head screwdriver
10 mm nut driver
6 mm allen wrench
(2) 13 mm nut drivers