Maintenance - Dometic 9200 Series Operating Instructions Manual

Power Awning

5 MAINTENANCE

 ELECTRIC SHOCK HAZARD. Disconnect product from power supply (if applicable), and do not
operate product when maintenance (such as window cleaning) is being carried out in the vicinity. Failure to obey
this warning could result in death or serious injury.
Failure to obey the following notices could damage the awning or other property:
• Do not use insecticides or other sprays near the awning fabric. These could cause stains, and could adversely
affect the fabric's ability to repel water.
• Do not expose the awning to adverse environmental conditions, corrosive agents, or other harmful
conditions.
• Do not allow the corner of the entry door to contact the awning fabric. Otherwise, premature wear or tearing
of awning fabric could occur.
• Never close the awning (for storage) when wet. The combination of moisture and dirt could result in mildew,
discoloration, and stains. If it is necessary to roll up awning (temporarily) while it's wet, make sure you roll it out
and let it dry (as soon as conditions allow) before rolling it up again.
• Do not allow dirt, leaves, or other debris to accumulate on the awning, which could cause abrasion and
stains. Mildew could grow on dirt and organic debris, causing permanent discoloration, stains, and odors to
the awning fabric.
• Do not use strong chemicals or abrasives to clean parts, as their protective surfaces will be damaged. Clean
awning hardware (as needed) with a mild surface cleaner.
• Do not use silicone sprays near labels. Otherwise, the label's adhesive bond to awning surfaces could
weaken.
5.1 Maintaining the hardware
11
Silicone Spray
FRTA
➤ Apply silicone spray lubricant as needed to the
moving parts on the fabric roller tube assembly.
EN
12
➤ Lubricate all pins and sliding surfaces of the arm
assemblies with silicone spray, as needed.
10