Cisco UCS 6332 Hardware Installation Manual page 42

Replacing a Fabric Interconnect
Procedure
Step 1
Contact Cisco TAC or your Cisco Sales representative to have them transfer the license to the replacement
fabric interconnect.
Step 2
Label the ports and the cables that you using so that you can refer to this information later. The cabling and
port numbering should be same for the replacement fabric interconnect.
Step 3
Log into UCS Manager and verify the state of the fabric interconnect, either active or subordinate. From the
CLI, enter the show cluster extended-state command. High availability (HA) should be running in UCS
Manager.
Example:
FI-A# show cluster extended-state
Cluster Id: 0x537d0580bf9911e0-0x8955000decd07984
A: UP, PRIMARY
B: UP, SUBORDINATE
A: memb state UP, lead state PRIMARY, mgmt services state: UP
B: memb state UP, lead state SUBORDINATE, mgmt services state: UP
heartbeat state PRIMARY_OK
INTERNAL NETWORK INTERFACES:
eth1, UP
eth2, UP
HA READY
Detailed state of the device selected for HA storage:
Chassis 1, serial: FOX1344G1R1, state: active
Chassis 2, serial: FOX1318GDKR, state: active
FI-A#
Step 4 Back up the software configuration.
Step 5
Use the fabric evacuation procedure on the subordinate fabric interconnect to ensure there is no data traffic
impact during the hardware replacement.
Step 6
Power down the subordinate fabric interconnect by unplugging it from the power source.
Example:
FI-A# show cluster extended-state
Cluster Id: 0x537d0580bf9911e0-0x8955000decd07984
A: UP, PRIMARY
B: DOWN, INAPPLICABLE
A: memb state UP, lead state PRIMARY, mgmt services state: UP
B: memb state DOWN, lead state INAPPLICABLE, mgmt services state: DOWN
heartbeat state SECONDARY_FAILED
INTERNAL NETWORK INTERFACES:
eth1, DOWN
eth2, DOWN
HA NOT READY
Peer Fabric Interconnect is down
Detailed state of the device selected for HA storage:
Chassis 1, serial: FOX1344G1R1, state: active
Chassis 2, serial: FOX1318GDKR, state: active
FI-A#
Cisco UCS 6300 Series Fabric Interconnect Hardware Installation Guide
40
<<<<<<<<<<<<<←---------------- HA is READY
Installing the Cisco UCS 6300 Series Fabric Interconnect