Advertisement
STEP 4 - Attaching Front Section to Rear Section
A. Slide the front boom into the rear boom making sure
to feed the UHF phasing lines into the holes near
the top of the cartridge housing, and into the slotted
pegs inside the housing. See FIGURE 4. When
finished, the phasing lines will be resting in the slots
of the pegs, but will not extend out the back side of
the cartridge housing.
B. Reinstall the director element, bolt and nut. See
FIGURE 2.
WARNING: Be sure the phasing lines DO NOT touch the
metal bracket or the antenna boom. See FIGURE 4.
STEP 5 - Cartridge Housing
A. Attach the cartridge housing cover so all 4 snaps
are locked in place. Direction of the housing does
not matter. See FIGURE 5.
STEP 6 - Corner Reflector Assemblies
A. Unfold the elements on the corner reflector booms.
Element clip tips should point away from the open
end of each boom. See FIGURE 6.
B. Attach the corner reflector booms using the supplied
nuts and bolts. See FIGURE 6
NOTE: The HD8200U antenna tuning stubs do not need
to touch the boom.
STEP 7 - Boom Brace
A. Install the boom brace by first removing the bolts
and hex nuts.
B. With the cartridge housing facing down, install the
boom brace to the top corner reflector boom first,
making sure the mast clamps are on the same side.
See FIGURE 7. Only finger tighten the bolt and
hex nut.
C. Swing the other end of the boom brace down onto
the rear section and insert the bolt and hex nut.
D. Tighten both bolts and nuts (on each end of the
boom brace) securely.
FIGURE 4 - Front Section to Rear Section
Cartridge Housing
FIGURE 5 - Attach Cartridge Housing
FIGURE 6 - Corner Reflector Assemblies
Element Clip Tips
V-shaped
tuning stub
FIGURE 7 - Boom Brace Installed
Install this
end first
Cartridge Housing,
(Facing Down)
UHF Phasing Lines
Be sure the phasing
lines DO NOT touch
the metal bracket or
the antenna boom.
Cartridge Housing
Pointing away from
open end of boom
Attach the corner
reflector booms
Mast
Clamps
Install this
end last
Advertisement
