Honda G100K2 Applications Manual page 5

ENGINE APPLICATION
Alignment of the engine PTO shaft and equipment shaft
Engine PTO shaft coupling
Engine inclination
Thrust and radial load on engine PTO shaft
Application / frame components
Non standard fuel tank: position, level, filter, ventilation and safety
Battery: size , position, connection
Electric wire size, fuses
Engine bed rigidity and flatness, frame rigidity
DYNAMIC CHECK OF THE APPLICATION
Full-loaded running test
Electric starter power requirement with cold engine: cranking current
Recoil starter pulling load
Engine speed setting: idle and maximum operating speed
Inclined usage operation
Required power output, governor performance
Cooling air flow in enclosed or semi-enclosed engine installation
Muffler heat radiation to other parts
Engine interference with frame or other parts during acceleration, deceleration, starting, stopping
Installation of covers, protectors and frame parts as possible sources of resonance vibration and noise
Flow of exhaust gas routed away from cooling air intake and air cleaner intake
Restarting performance of engine in hot condition: vapor lock
Engine vibration on different operating speeds
Engine component temperatures during a 1 hour full-loaded test cycle
Muffler afterburn at engine stop
Backpressure of non-standard exhaust system
- 4 -