Menus; View Menu - Tekmar D 512 Data Brochure

Heating / Cooling Interlock
Time Interlock
In order to prevent frequent changes between heating and cooling, the thermostat
has a Cooling Interlock setting. Once the Heat 1 relay has been off for a minimum of
one heating cycle or the length of the Cooling Interlock, (whichever is longer) cooling
is permitted
Temperature Interlock
When in the Auto mode, the cooling temperature is limited to 3°F (1.5°C) above the
heating temperature. If the cooling temperature is set below the heating temperature,
the thermostat automatically adjusts the cooling setpoint
When operating in the Cool mode, there is no interlock between the heating and cooling
temperature.
View Menu (1 of 1)
© 2009 D 512 - 09/09
.
ROOM TARGET
The current desired air temperature for the space. This item is
only available in the Installer access level.
(Must have an active air sensor.)
ROOM
The current air temperature for the space.
(Must have at least one active air sensor. This is the average of
all active air sensors.)
OUTDOOR
The current temperature at the outdoor sensor .
(Sens 2 must be set to Out.)
SLAB
The current slab temperature.
(Must have an active slab sensor. If two slab sensors are present,
this is the average temperature.)
The MIN segment is displayed when running on Min.
REMOTE
The current temperature at the remote sensor.
(Sens 1 must be set to Rem.)
6 of 20
.