Table of Contents
Advertisement
Rear brake pedal
Loosen lock nut (4).
Turn pedal stroke adjusting screw (5) until pedal is in
the desired position. Tighten the lock nut (4).
Operate the pedal by hand to check that there is 1.5 to
2 mm (0.06÷0.08 in) of free play before the brake
bites. If not, adjust the length of the master cylinder
control rod as follows.
Loosen lock nut (6) on master cylinder rod.
Screw the rod (7) into the fork (8) to increase the free
play, or screw it out to reduce it.
Tighten lock nut (6) and check play again.
6
7
8
5
4
Fig. 95
143
Advertisement
Table of Contents
