Siemens 2010 User Manual page 7

19.04.2000 2010-
euroset 2010,IM1, A31008-E2010-B100-2-3S19
Switching the dialing mode
Lift the handset, then start the function.
1 = Tone dialing,
or
2 = Pulse dialing without flash function.
Press the set key, then replace the handset.
Switching the dialing mode while connected
If your telephone is set to pulse dialing and you want to use functions that
require tone dialing (e.g. remote replay on an answering machine), you can
switch the dialing mode while connected.
While connected: press the asterisk key.
The dialing mode is switched.
Enter the digits for remote control/ data transfer.
Replacing the receiver resets the telephone to the original dialling mode.
Recall key (use on private PABXs)
During a trunk call, you can make an enquiry call or transfer a call. To do
this, press the recall key . The next step depends on your PABX. In the
factory setting, the recall key function is set to a flash time (interrupt time)
of 90 ms to permit new features to be used on p p ublic telephone systems.
When your telephone is connected to a private PABX, it may be necessary
to change the flash time (e.g. 600 ms). Please check the operating instruc-
tions for your PABX.
Setting the flash time for the recall key
Lift the handset then start the function.
Enter the required flash time number:
...
0: 90 ms (factory setting);
2: 270 ms;
Press the set key, then replace the handset.
1 1 : 120 ms,
3 3 : 375 ms, 4 4 : 600 ms.
– 7 –
- English -