Table of Contents
Advertisement
Wireless Multiple Flash Shooting
You can divide the slave units into two or three groups and perform
TTL autoflash while changing the flash ratio (factor). In addition, you
can set and shoot with a different flash mode for each firing group,
for up to 3 groups.
● Auto Shooting with Two Slave Groups
● Auto Shooting with Three Slave Groups
The Reason & Solution of Not Triggering in Godox 2.4G Wireless
1. Disturbed by the 2.4G signal in outer environment (e.g. wireless base
station, 2.4G wifi router, Bluetooth, etc.)
→ To adjust the channel CH setting on the flash trigger (add 10+ channels) and
use the channel which is not disturbed. Or turn off the other 2.4G equipment
in working.
2. Please make sure that whether the flash has finished its recycle or caught up
with the continuous shooting speed or not(the flash ready indicator is lighten)
and the flash is not under the state of over-heat protection or other abnormal
situation.
→Please downgrade the flash power output. If the flash is in TTL mode, please
try to change it to M mode(a preflash is needed in TTL mode).
3. Whether the distance between the flash trigger and the flash is too close or
not
→Please turn on the "close distance wireless mode" on the flash trigger (＜0.5m):
X1 series: press the test button and hold on, then turning it on until the flash
ready indicator blinks for 2 times.
XPro series: Set the C.Fn-DIST to 0-30m.
4. Whether the flash trigger and the receiver end equipment are in the low
battery states or not
→Please replace the battery(the flash trigger is recommended to use 1.5V
disposable alkaline battery).
Other Applications
Auto Focus Assist Beam
In poorly-lit or low-contrast shooting environments, the built-in auto
focus assist beam will automatically light on to make it easier for
autofocus. The beam will light up only when autofocus is difficult
and get out as soon as the autofocus becomes correct.
If you want to turn off the auto focus assist beam, set the "AF" to
"OFF" on the C.Fn settings.
Note: When attaching to the camera, the auto focus assist
●
beam of TT350F can only be lighted by setting its focus
mode (M/C/S) to S mode. The other two modes cannot
light up its auto focus assist beam.
- 41 -
A
B
C
A
B
Position
Effective Range
Center
0.6~4m
Periphery
0.6~2.5m
Bounce Flash
By pointing the flash head toward a wall or ceiling, the flash will
bounce off the surface before illuminating the subject. This can
soften shadows behind the subject for a more natural-looking shot.
This is called bounce flash.
To set the bounce direction, hold the flash head and turn it to a
satisfying angle.
270
If the wall or ceiling is too far away, the bounced flash might
●
be too weak and result in underexposure.
The wall or ceiling should be a plain, white color for high
●
reflectance. If the bounce surface is not white, a color cast
may appear in the picture.
Creating a Catchlight
With the catchlight panel, you can create a catchlight in the subject's
eyes to add life to the facial expression.
1
2
3
-7-90
Point the flash head upward by
90°.
Pull out the wide panel. The
catchlight panel will come out
at the same time.
Push the wide panel back in.
●
Push in only the wide panel.
Follow the same procedures
●
as for bounce flash.
- 42 -
Hide quick links:
Advertisement
Table of Contents
