English
12
Preparing the room for a cleaning run
Using your robot
Starting and stopping
Before you start the robot on its cleaning run, make sure that you remove
all loose and fragile objects from the floor. Also remove all cables,
wires and cords from the floor.
You can also operate your robot with the remote control (FC8932 only)
or with the buttons on the user interface of the robot.
1 Set the power switch on the side of the robot to the 'on' position.
2 Press the start/stop button.
-
You can press the start/stop button on the robot.
-
You can also press the start/stop button on the remote control
(FC8932 only)
3 The start/stop button is continuously on and the robot starts cleaning.
4 The robot cleans in the auto-cleaning mode until its battery runs low.
In the auto-cleaning mode, it follows repeated sequences of Z-pattern,
random, wall-following and spiral patterns.
Note: To select an individual mode, press one of the mode buttons on
the remote control. See section 'Cleaning mode selection' for more
details.