Important Safety Instructions - ControlOMatic MegaChlor Operating Instructions Manual

IMPORTANT SAFETY INSTRUCTIONS

READ & FOLLOW ALL INSTRUCTIONS
When installing and using this electrical equipment, basic safety precautions should
always be followed, including the following:
WARNING: Cutting the cord from the power supply to the MegaChlor cell voids the warranty.
Damage will occur if the connection is reversed.
WARNING: To reduce the risk of injury, do not permit children to use this product unless they
are closely supervised at all times.
WARNING: Use MegaChlor only according to these instructions. Any modification or misuse
of this product will void the warranty.
WARNING: Install MegaChlor in accordance with all national and local electrical, plumbing,
safety, and other applicable codes.
WARNING: Connect MegaChlor to a GFCI (ground fault circuit interrupt) or GFI (ground fault
interrupt) protected VAC power source only.
WARNING: Protect the power supply and outlet from exposure to the elements including
direct sun, rain, snow, condensation, etc.
WARNING: DO NOT use with extension cord. Injury may result.
WARNING: DO NOT operate MegaChlor if damaged in any way.
WARNING: DO NOT pull on the cord to disconnect the Power Supply from power source. Do
not allow the cord be walked on, or to rest on sharp edges or corners. Do not drop, throw, or
otherwise rough handle MegaChlor.
WARNING: DO NOT operate or leave the power supply in temperatures below 32ºF or 0ºC.
The power supply may not survive in extremely cold temperatures.
WARNING: Disconnect, remove and store MegaChlor indoors when pool has been winterized
or drained.
CAUTION: Leave spa/pool cover open at least 1 minute to allow trapped gases to escape
prior to use.
CAUTION: Measure water quality parameters and adjust if necessary prior to each spa use.
CAUTION: MegaChlor doesn't measure the chlorine level and must be adjusted properly in
order to not over-chlorinate the water. Over-chlorination can lead to equipment damage and
un-healthy water conditions.
WARNING: Remove the MegaChlor cell from the SPA when using the SPA.
WARNING: DO NOT handle the MegaChlor cell during chlorine production (visible bubbling).
Slight discomfort may be felt in cuts, sores, or sensitive skin areas due to chlorine
concentration and the electrolysis process.
WARNING: DO NOT insert objects into, or tamper with the MegaChlor cell in any way.
Inserting metal objects into the cell body may cause damage and void the warranty.
WARNING: DO NOT plug MegaChlor control box directly into the VAC supply, this will
damage the MegaChlor. Always use the low voltage power supply.
SAVE THESE INSTRUCTIONS