Important Safety Instructions - ControlOMatic ChlorMaker Operating Instructions Manual

IMPORTANT SAFETY INSTRUCTIONS

READ & FOLLOW ALL INSTRUCTIONS
When installing and using this electrical equipment, basic safety precautions should
always be followed, including the following:
WARNING: Cutting the cord from the power supply to the ChlorMaker cell voids the warranty.
Damage will occur if the connection is reversed.
WARNING: To reduce the risk of injury, do not permit children to use this product unless they
are closely supervised at all times.
WARNING: Use ChlorMaker only according to these instructions. Any modification or misuse of
this product will void the warranty.
WARNING: Install ChlorMaker in accordance with all national and local electrical, plumbing,
safety, and other applicable codes.
WARNING: Connect ChlorMaker to a GFCI (ground fault circuit interrupt) or GFI (ground fault
interrupt) protected VAC power source only.
WARNING: Protect the power supply and outlet from exposure to the elements including direct
sun, rain, snow, condensation, etc.
WARNING: DO NOT use with extension cord. Injury may result.
WARNING: DO NOT operate ChlorMaker if damaged in any way.
WARNING: DO NOT pull on the cord to disconnect the Power Supply from power source. Do
not allow the cord be walked on, or to rest on sharp edges or corners. Do not drop, throw, or
otherwise rough handle ChlorMaker.
WARNING: DO NOT operate or leave the power supply in temperatures below 32ºF or 0ºC. The
power supply may not survive in extremely cold temperatures.
WARNING: Disconnect, remove and store ChlorMaker indoors when spa has been winterized
or drained.
CAUTION: Leave spa cover open at least 1 minute to allow trapped gases to escape prior to
use.
CAUTION: Measure water quality parameters and adjust if necessary prior to each spa use.
CAUTION: ChlorMaker doesn't measure the chlorine level and must be adjusted properly in
order to not over-chlorinate your spa. Over-chlorination can lead to spa damage and un-healthy
water conditions.
WARNING: Remove the ChorMaker cell from the SPA when using the SPA.
WARNING: DO NOT handle the ChlorMaker cell during chlorine production (visible bubbling).
Slight discomfort may be felt in cuts, sores, or sensitive skin areas due to chlorine concentration
and the electrolysis process.
WARNING: DO NOT insert objects into, or tamper with the ChlorMaker cell in any way.
Inserting metal objects into the cell may cause damage and void the warranty.
WARNING: DO NOT plug ChlorMaker control box directly into the VAC supply, this will damage
the ChlorMaker. Always use the low voltage power supply.
SAVE THESE INSTRUCTIONS