Related Manuals for ControlOMatic TECHNICHLOR
Summary of Contents for ControlOMatic TECHNICHLOR
- Page 1 ECHNI HLOR PERATING NSTRUCTIONS ControlOMatic, Inc. 12659 Arbor Lane Grass Valley, CA 95949 www.controlomatic.com support@controlomatic.com 530-205-4520 Manual Version: 3/30/15 TechniChlor Serial Numbers starting with 87 Made in the USA...
- Page 2 WARNING: Remove the TechniChlor from the SPA when using the SPA. WARNING: Cutting the cord from the power supply to the TechniChlor cell voids the warranty. Damage will occur if the connection is reversed.
- Page 3 NaCl) dissolved in the spa water. The amount of salt added is very small in relation to the volume of the water in the spa. The concentration required for the TechniChlor is only about 5% of the salt level of ocean water and below the typical taste level of most humans.
- Page 4 NOTE: It may take the TechniChlor a few hours to register the salt level the first time. Wait a couple of hours for the salt to dissolve, and then turn on the TechniChlor.
- Page 5 TechniChlor has temperature compensation and if the water is warm allow the TechniChlor about 15 minutes to warm up to the spa’s temperature (if the TechniChlor is cold when it is on it will only stay on a few minutes and go into standby mode).
- Page 6 LIGHTS OFF: This mode lasts 30 minutes and is used to keep the lights off when you are using the spa. If the TechniChlor is making chlorine (bubbles leaving the cell) then take it out of the water to enter this mode, or a single tap will put it into this mode.
- Page 7 Ÿ Remove the TechniChlor from the water Ÿ Turn off the AC voltage to the TechniChlor for 5 or more seconds and then turn it back on Ÿ After the startup sequence, the TechniChlor will start to slowly flash 4...
- Page 8 Boost Mode after a 30 minute delay (no lights). Re-submerge and after a 30 minute delay, TechniChlor will indicate that its in a Boost Mode Cycle when all four (4) lights are BLUE while its producing chlorine.
- Page 9 Check chlorine levels before and after vacation to make sure proper chlorine levels are maintained. The TechniChlor temperature is displayed after the light test when the power is cycled or 6 taps. Count the flashes for the temperature in degrees Fahrenheit and each flash has the following value:...
- Page 10 Ÿ Check if in the standby part of the cycle, watch and see if the GREEN lights flash every 10 seconds Ÿ The TechniChlor may be near a jet and was pushed by the water causing a tap, this will keep it off for 30 minutes with no lights Ÿ...
- Page 11 Notes:...
- Page 12 Models: This warranty applies to TechniChlor model referenced as “System”. ControlOMatic, Inc. Warrants the system to be free of all defects in material and workmanship for one (1) year from the owners original purchase date. The system includes the power supply unit, cable, electronics, and electrolytic generator for residential use only.
Need help?
Do you have a question about the TECHNICHLOR and is the answer not in the manual?
Questions and answers