Related Manuals for ControlOMatic TechniChlor
Summary of Contents for ControlOMatic TechniChlor
- Page 1 ECHNI HLOR PERATING NSTRUCTIONS ControlOMatic, Inc. 12659 Arbor Lane, Grass Valley, CA 95949 www.ControlOMatic.com Support@ControlOMatic.com 530-205-4520 Manual Version: 2/1/14 Made in the USA...
- Page 2 Only 2.5 cups of salt per 100 gallons of water is all it takes for TechniChlor to produce fresh, pure chlorine leaving your water clean and clear day after day. IMPORTANT SAFETY INSTRUCTIONS READ &...
- Page 3 TechniChlor will significantly reduce the amount of spa maintenance required, but chemical check- ups including chlorine levels and PH are recommended before each use. Proper water maintenance will prolong the life of TechniChlor and the spa. The following table describes generally accepted optimum water chemistry for portable spas.
-
Page 4: Salt Requirement
SALT REQUIREMENT TechniChlor can generate both Chlorine or Bromine. It all depends on which sanitizer the user prefers. Use Sodium Chloride Salt if you prefer Chlorine Generation and Sodium Bromide Salt if you prefer Bromine. Please Note: Each salt requires a different level of salinity for TechniChlor to operate effectively. WARNING: SALT ONLY... -
Page 5: Product Installation
Plug TechniChlor into a 110 VAC wall outlet. WARNING: A 110 VAC GFCI or GFI protected outlet is required. A weather protective cover is required to house the power supply at the power source connection. - Page 6 Plug Technichlor into the GFCI protected outlet, and after a brief pause, the unit will begin chlorine production. NOTE: If there are Solid...
-
Page 7: Product Operation
It will then confirm the new power level by counting the flashes. • POWER & DIP - Cycle Main Power Off & On: Simply pull TechniChlor out of the water and unplug TechniChlor form the power source or shut off power at the main breaker. Wait 10 seconds and turn the power back on. -
Page 8: Selecting The Right Power Level
However, after the testing and adjustment period, TechniChlor will take care of your sanitation needs day after day. As a starting point, please program TechniChlor and set the power level to the general recommendations shown in the chart below. -
Page 9: Troubleshooting
Lights: BOOST MODE Production - Salt level is within normal range 4 Solid Lights: BOOST MODE Production - Salt level is on low side of range When TechniChlor is not producing chlorine; GREEN Lights Quick Flash Every 10 Seconds: Indicating Normal Standby Mode (off time) After One (1) Single Tap (Boost Mode With 30 Minute Delay);... -
Page 10: Limited Warranty
Models: This warranty applies to TechniChlor models referenced as “System”. ControlOMatic, Inc. Warrants the system to be free of all defects in material and workmanship for one (1) year from the original purchase date. The system includes the power supply unit, cable, electronics, and electrolytic genera- tor for residential use only. - Page 11 ECHNI HLOR Go To www.ControlOMatic.com For More Product Information...
-
Page 12: Product Registration
PRODUCT REGISTRATION Please fill out the information below and send to ControlOMatic to properly register your prod- uct. Or register your product on line at www.ControlOMatic.com. First Name: Last Name: Address: City: State / Province: Postal Code: Phone: E-Mail: Please copy this section and forward a copy to ControlOMatic, Inc.
Need help?
Do you have a question about the TechniChlor and is the answer not in the manual?
Questions and answers