Advertisement
Assembly and Installation
Positive Cable
Red Tip
(To Positive Battery Terminal)
Electric Cable Connection
Attach the black (negative) ground
cable to motor terminal and black
solenoid ground wire with brass bolt.
Tighten the brass bolt onto terminal
using a 13mm wrench. Then attach
positive and negative cables to their
corresponding battery terminals.
DO NOT OVER TIGHTEN.
Fire/Electrical Spark/Chemical Burn Hazards:
Connecting winch to battery and winch operation may cause
electrical arcs. Never install or use winch where gasoline leaks,
vapors or other flammables are present.
Always wear eye protection & remove jewelry when working with
battery or installing winch electrical cables. Plan connections to
avoid fuel lines, hot or rotating parts. Never route electrical cable
or winch controller across sharp edges, doors or other pinch
points.
Always use supplied terminal boots, insulate any other exposed
connections neatly support all wiring. Depending on your level of
knowledge regarding electrical wiring, you may wish to have this
procedure performed by a qualified technician.
Negative Ground Cable
Black Tip (To Negative
Terminal on Battery)
The Trusted Source
3
Motor Stator
Cable Yellow
Motor Rotator
Cable Red
Motor Stator
Cable Green
Solenoid Ground
Wire (See below)
Motor
& Solenoid
Ground Wires
Advertisement
