Introduction; Scope; Purpose; Who Should Use This Document - Siemens FDK:085U0321 Operating Instructions Manual

HART add-on module
1.

Introduction

1.1

Scope

1.2

Purpose

1.3 Who should use
this document?
1.4 Abbreviations and
Definitions
1.5

References

2. Device
Identification
4
1. Introduction / 2. Device Identification
The Siemens HART interface for use with SITRANS F flow transmitters: MAG 5000 C, MAG 6000
and MASS 6000, revision 2, complies with HART protocol Revision 5.2. This document specifies
all the device specific features and documents HART Protocol implementation details (e.g. the
Engineering units supported). The functionality of this device is described sufficiently to allow its
proper application in a process and its complete support in HART capable Host Applications.
This specification is designed to compliment the operating manuals for MAG 5000 C, MAG 6000
and MASS 6000 flow transmitters by providing a complete, unambiguous description of this Field
Device from a HART communication perspective.
This operating manual does NOT cover MASS 6000 Ex d, MAG 6000 Industry and MAG 6000
Industry Ex d.
The specification is designed to be a technical reference for HART capable Host Application
Developers, System Integrators and knowledgeable End Users. It also provides functional
specifications (e.g., commands, enumerations and performance requirements) used during
Field Device development, maintenance and testing. This document assumes the reader is
familiar with HART Protocol requirements and terminology.
AOM Add-On-Module
USMII Concept with flexible plug & play fieldbus modules
SensorProm Storing unit for all settings
HCF HART communication foundation
FSK Frequency Shift Keying physical layer
CN Capacitance number; capacitance as a multiple of 5000 pF
pF Picofarad (10
PV Primary variable
SV Secondary variable
TV Tertiary variable
QV Quaternary variable
Literature 1 MAG 5000 C/MAG 6000 operating manual Order No FDK-521H0739
Literature 2 MASS 6000 operating manual Order No FDK-521H0991
This operating manual covers the specifications of the HART interface for MAG 5000 C, MAG 6000
and MASS 6000.
All HART interfaces are based on the same Firmware and Hardware. Below is a table showing
the relations between the flow transmitters and the HART interfaces.
MAG 5000 C
MAG 6000
MASS 6000
MAG 6000 Industry*
MAG 6000 Industry (Ex d)*
MASS 6000 Ex d*
* Not described in this operating manual
Devices with the following Firmware version and up are covered in this operating manual.
HART module
MAG 5000 C
MAG 6000
MASS 6000
-12 Farad); unit of electrical capacitance
HART interface
FDK:085U0226 FDK:085U0321
X
X
X
Firmware
2.00
3.03
3.03
3.00
Integrated
X
X
X