Connecting The Temperature Sensor; Figure 3-7 Sensor Module ① Mounted On Terminal Box - Siemens 1PH728 Operating Instructions Manual

NOTICE
Do not turn the Sensor Module with a pipe wrench or hammer or any similar tool as this
could damage the Sensor Module.
Turn the Sensor Module by hand.
Typical twisting moment:
Figure 3-7
NOTICE
Changing the cable outlet direction by any improper means will cause damage to the
connecting cables.
The permissible rotation range must not be exceeded. A maximum of ten changes to the
rotation angle of the Sensor Module are permissible within the rotation range.
[ID 964]
3.3.7

Connecting the temperature sensor

Connection
Connect the wires of the temperature sensor to the speed sensor connector with the aid of
connecting leads (see section entitled "Connecting the speed sensor").
A5E00177602A AD
Siemens AG Operating Instructions 2.02 1PH728
Siemens Hardware
4 ... 8 Nm
Sensor Module ① mounted on terminal box
Transport, assembly, and connection
3.3 Electrical connection
37