Ingersoll-Rand ARO 613201-3-C Operator's Manual

OPERATOR'S MANUAL
INCLUDING INSTALLATION & OPERATION
ALSO INCLUDE MANUALS 66610X-X-C (97999-100) & 67144 (97999-953)
It is the responsibility of the employer to place this information in the hands of the operator. Keep for future reference.
SERVICE KITS
D Use only genuine ARO
R
pressure rating and longest service life.
D 637118-C for diaphragm pump air section repair.
D 637119-41-C for diaphragm pump fluid section repair.
GENERAL DESCRIPTION
Operator's Manual 66610X-X-C (pn 97999-100) should be used for
General Information, Installation, Operation and Maintenance.
The 613201-3-C pump system has been designed for the purpose of
evacuating and filling tires with calcium chloride ballast solution. It uti-
lizes the 67144 1" metallic diaphragm pump, which features an alumi-
num body and fluid manifolds, neoprene diaphragms and PTFE balls for
pumping the corrosive calcium chloride ballast solution. The diaphragm
pump has a 1:1 ratio, which means the fluid outlet pressure will be
approximately equal to the available air inlet pressure. Although the
pump is capable of high volume delivery (upwards of 25 g.p.m. at 100
p.s.i.), filling and evacuating times will take longer due to the small re-
stricting diameter of the tire valve.
Dispensing Hose
Control Valve
INGERSOLL RAND COMPANY LTD
209 NORTH MAIN STREET – BRYAN, OHIO 43506
(800) 276-4658 FAX (800) 266-7016
www.ingersollrandproducts.com
613201-3-C
Utilizing the ARO 1" Metallic Diaphragm Pump
(1:1 Ratio - Calcium Chloride Compatible)
READ THIS MANUAL CAREFULLY BEFORE INSTALLING,
OPERATING OR SERVICING THIS EQUIPMENT.
replacement parts to assure compatible
613201-3-C TIRE FILL SYSTEM
CCN 15230121
© 2010
Tire Fill System
INSTALLATION - SET UP
The operator should make certain adequate air supply is available to the
pump, be cautious of long air lines and restrictions or other effects on the
air inlet pressure.
Assemble the hose / strainer and gun assembly to the pump (see figures
2 and 3) as shown. Be certain hoses are connected to proper sides of the
siphon valve.
SAFETY PRECAUTIONS
Z Read and heed all Warnings, Cautions and Safety Precautions
before operating this pump.
WARNING DO NOT EXCEED MAXIMUM INLET AIR PRES-
SURE OF 120 P.S.I. (8.3 BAR). Operating pump at higher pres-
sure can cause pump damage.
WARNING HAZARDOUS PRESSURE. Can result in serious
injury or property damage. Do not service or clean pump,
hoses or dispensing valve while the system is pressurized.
CAUTION Be certain all operators of this equipment have
been trained for safe working practices, understand it's limita-
tions and wear safety goggles / equipment when required.
Air Inlet
613201-3-C
RELEASED:
REVISED:
(REV. 02)
Supply Hose
Screened Inlet
Figure 1
7-21-04
5-13-10